What Have You Done To Your Bike Today?

[jack0305]

I didn't do anything to my bike today except move it, forgetting to dry the seat 1st leaving me with a moist rump. Most annoying.

 

[Friz]

New tires on the way?

Yes, finally.

They have had no tred on them for the past month or 2 :lol:

What tyres are you getting?

Michelin Pilot Road 3

After the suggestions of a few people on here.

 

[sstimmyy]

Are there stairs in your house?

A house would have to have stairs, or it would be a bungalow.

What if it had a ladder?

 

[Chessecake94]

I changed the broken rear brake light bulb, so the cops don't stop me again.

 

[CurlyBlakey]

I sat at home working out how i'm going to repay mum the rather large bill from the garage to have mine fixed! i'm gonna be skint till july!

CB what was the bill on the bike & what did you get done if you don't mind me asking?

Bill will be c£600 for new starter clutch, new fuel tap and pipes and full service.

More than i was expecting but it would cost me a lot more if i tried to do it i.e. i'd ruin the bike!

 

[Chuckles85]

I attacked the chain with a toothbrush and chain cleaner, washed it all off, then re-applied the lube. Boy it looks 10x better for it. That's what I did today.

 

[lawman]

Not quite today, im still in bed...
Put my poor little KTM through this on sunday....
[youtube]http://www.youtube.com/watch?v=lQso0nALD9A[/youtube]

 

[Chessecake94]

It's currently at the garage, having a service, MOT, new battery, new chain and sprockets.

 

[senthx]

rode it 150 miles on the motorway in pouring rain, and booked it in for a service

 

[Chessecake94]

It's currently at the garage, having a service, MOT, new battery, new chain and sprockets.

Add new rear wheel bearings to that

 

[Stenno]

I meant to change out my horn today as it never works when I want to use it... but I forgot! This weekend... maybe!

 

[10feetup]

I fitted a new bar end weight, as one was missing when i bought the bike.

 

[Yarek]

Today I've just spent a while adjusting the suspension and tyre pressures to make sure the suspension was set up as standard and the tyre pressures to the manufacturers recommendation (and that of the street triple forum owners recommendation) rather than that specified in the bike manual (which apparently is best for people with a bit more weight than me).

 

[ToySoldier]

iv taken the exhaust off my ts50 and started to sand it all down and re paint it so it wont rust throw.

 

[ToastToGo]

I fitted a new bar end weight, as one was missing when i bought the bike.

Weird things when buying a used bike...

 

[lauriejennifer]

Took off fairings, seat, and gas tank-- and then opened the top of the carb, removed needle jet, and adjusted clip setting. Doesn't run quite so rich anymore. Still needs smaller pilot jet.

 

[Friz]

 

[Trinith]

I haven't said anything here for a few days because they've all been the same. "I rode it."

 

[ToastToGo]

Took off fairings, seat, and gas tank-- and then opened the top of the carb, removed needle jet, and adjusted clip setting. Doesn't run quite so rich anymore. Still needs smaller pilot jet.

When are you getting it dyno tuned ?

Cha ching!!!

 

[Friz]

Cha ching!!!

Its going to be odd riding on tyres with tread!
And that aren't square :lol: