tarmacjapa
Bike Hub Japan
What's up guys...
I changed up my setup a little. I got the new Ulanzi V2 case for holding the mic adapter together with the GoPro. The shape of the TX3 being a bugger meant that I was slightly worried about the 3M tape only having 1/2 of the surface area it needed with the heavier setup of the Ulanzi case and the mic adapter being together... so I bonded the GoPro base plate on with some epoxy. It's a bit messy but I'll tidy it up by sanding it down a little and maybe squeezing some silicone sealant in there...
I 3M'd a little bracket to hold the mic adapter to mic section just to stop it flapping about in the wind.
Did a bit of work on the mic holder in the chin bar too. Trimmed the dead cat too. Nothing like shaving a grey haired pussy...
Test tomorrow...
I changed up my setup a little. I got the new Ulanzi V2 case for holding the mic adapter together with the GoPro. The shape of the TX3 being a bugger meant that I was slightly worried about the 3M tape only having 1/2 of the surface area it needed with the heavier setup of the Ulanzi case and the mic adapter being together... so I bonded the GoPro base plate on with some epoxy. It's a bit messy but I'll tidy it up by sanding it down a little and maybe squeezing some silicone sealant in there...
I 3M'd a little bracket to hold the mic adapter to mic section just to stop it flapping about in the wind.
Did a bit of work on the mic holder in the chin bar too. Trimmed the dead cat too. Nothing like shaving a grey haired pussy...
Test tomorrow...
Last edited by a moderator:
