Mounting Gopro On A Shoei Helmet

[Moby]

I'm having a hard time mounting the GoPro to my helmet. The curved mount isn't curved enough to mount it on the chin, and it's curved too much to mount on the side of the helmet. The flat adhesive mount won't fit anywhere. I tried to find adhesive mounts with different curvature on ebay but no luck there. Any help would be welcome.

 

[MotoJedeye]

Just use the chest mount.

 

[SwissMotard]

Which Shoei helmet? They're all very different.

 

[Runnin1ife]

I actually trimmed a mount to fit off centered on my bell vortex. Then ran a few of the arms to get it centered.
Here is the link to where I got the idea from.

 

[SighBored]

You won't get a complete coverage of the sticky with the helmet surface, try filling the gaps with more sticky tape, it should be sturdy enough.

 

[Fobs]

I actually trimmed a mount to fit off centered on my bell vortex. Then ran a few of the arms to get it centered.
Here is the link to where I got the idea from.

I have never seen this set-up but i will try it out on one of my new motovlogs... Thanks for sharing...

 

[Arctic Pride]

use a heat gun to mold the mounts the way you need them to just not so much that it bends the slide