Feedback Needed My Bike Modifications!

[CDA441]

Well I've edited it down to as short as I can make it to still cover everything, but I'm still at 10 minutes...

I still need an intro, have something in mind, but it's too difficult to actually make it.
Consists of:
1) Key in ignition
2) Pressing start button
3) Switch to exhaust camera
4) Ride away
Should take about max 7 seconds, but it'll take 1 hour to film :')

Feedback is more than welcome!

 

[R-Rated]

I like the rubber sleeve for the brake lever idea. Did you use some kind of glue to make sure it does not wiggle off too easy?

Plus the mesh over the radiator is another great idea.

 

[CDA441]

I like the rubber sleeve for the brake lever idea. Did you use some kind of glue to make sure it does not wiggle off too easy?

Plus the mesh over the radiator is another great idea.

Thanks!
The rubber sleeve is just a tight fit, barely slipped over the brake lever with the use of a bit of compressed air.
Doesn't wiggle a lot, but much more slip resistant than the bare metal.
The trashcan radguard was an old idea, had an oil cooler on my previous bike and didn't want to spend a lot on it. But it works perfectly