Bluetooth & Hero 4

[Mr fish]

Right I'm fed up with my mics keep failing and having to drill holes then try and waterproof the gap Sooooooooo ..Im going to sell a kidney and get a Go pro hero 4 black and send 20s

Does anyone run this configuration if so any problems ? and can you point me in the direction of motovloggers that use this set up

Many thanks from the man they call FISH

 

[Marbro_za]

quite a few use this afaik
Think c2w does
Think Dan from this forum does too

 

[Lurch]

Psst!

Drift!

 

[Mr fish]

Psst!

Drift!

I looked into drift but still need wired mic which is my main annoyance and 1080 is the maximum (future proofing)

 

[Lurch]

No need to waterproof the Drift though. Had mine in some proper downpours and it's been fine. Worst case pull the mic and shut the rubber flap, and that can be done on the fly.

 

[Marbro_za]

how big is this fly?

 

[BlackMamba]

Well lurch is over 6" tall for for him to be sat on it it has got to be atleast 5"tall and 7"long with a wing span of 8"?

 

[Lurch]

Like all of the world's population, I'm a bit more than 6" tall...

 

[BlackMamba]

Foot..............................................................

 

[Lurch]

That'll be 6' then

 

[BlackMamba]

' " there is barely 11" in it!

 

[SwissMotard]

What was this topic about again?

 

[BlackMamba]

Lurch riding a giant fly ofc!

 

[Lurch]

It's about Fishmeister following the KISS principle and buying a Drift

 

[Mr fish]

No need to waterproof the Drift though. Had mine in some proper downpours and it's been fine. Worst case pull the mic and shut the rubber flap, and that can be done on the fly.

Once I'm moving i can't be bothered to stop

 

[Mr fish]

Plus i want super wide

 

[Lurch]

Once I'm moving i can't be bothered to stop

Don't need to stop. If you can reach the cam, you pull the jack and press the door shut.

 

[Mr fish]

And I run a chin mount

 

[SighBored]

Drilling holes to the helmet is not recommended. Have you considered hot-gluing the stem of the mic to the inner of the helmet? In fact if you wanted to keep it permanent you could hot-glue the entire wire to the helmet, I think.

 

[Mr fish]

Drilling holes to the helmet is not recommended. Have you considered hot-gluing the stem of the mic to the inner of the helmet? In fact if you wanted to keep it permanent you could hot-glue the entire wire to the helmet, I think.

When I said about drilling holes i meant in the go pro waterproof case not the helmet ...i would never drill into a helmet